| PETHTOOL(8) | [FIXME: manual] | PETHTOOL(8) |
NAME¶
pethtool - Display or change ethernet card settings
SYNOPSIS¶
pethtool [OPTIONS] [<INTERFACE>]
DESCRIPTION¶
This script mimic ethtool behavior, but is written purely in python and python module ethtool.
OPTIONS¶
INTERFACE
Is the name of the ethernet device on which pethtool
should operate.
-h, --help
Show help message and exit.
-c|--show-coalesce
Show coalesce options
-C|--coalesce
Set coalesce options
adaptive-rx on|off adaptive-tx on|off rx-usecs N rx-frames N rx-usecs-irq N rx-frames-irq N tx-usecs N tx-frames N tx-usecs-irq N tx-frames-irq N stats-block-usecs N pkt-rate-low N rx-usecs-low N rx-frames-low N tx-usecs-low N tx-frames-low N pkt-rate-high N rx-usecs-high N rx-frames-high N tx-usecs-high N tx-frames-high N sample-interval N
-i|--driver
Show driver information
-k|--show-offload
Get protocol offload information
-K|--offload
Set protocol offload
[ tso on|off ]
SEE ALSO¶
AUTHORS¶
Arnaldo Carvalho de Melo <acme@redhat.com>
Man page written by Miroslav Suchý <msuchy@redhat.com>
| 03/22/2017 | [FIXME: source] |