NAME¶

sg_referrals - send SCSI REPORT REFERRALS command

SYNOPSIS¶

sg_referrals [--help] [--hex] [--lba=LBA] [--maxlen=LEN] [--one-segment] [--raw] [--verbose] [--version] DEVICE

DESCRIPTION¶

Send the SCSI REPORT REFERRALS command to the DEVICE and outputs the response. This command was introduced in (draft) SBC-3 revision 24 and devices that support referrals should support this command.

The default action is to decode the response for all user data segment referral descriptors. The amount of output can be reduced by the --lba and --one-segment options.

OPTIONS¶

Arguments to long options are mandatory for short options as well.

-h, --help: output the usage message then exit.
-H, --hex: output response to this command in ASCII hex.
-l, --lba=LBA: where LBA is the Logical Block Address (LBA) in the first user data segment the DEVICE should report the referrals parameter data for.
-m, --maxlen=LEN: where LEN is the (maximum) response length in bytes. It is placed in the cdb's "allocation length" field. If not given then 256 is used. 256 is enough space for the response header and user data segment descriptors.
-s, --one-segment: report the user data segment of the segment spefified by the LBA parameter only.
-r, --raw: output response in binary (to stdout).
-v, --verbose: increase the level of verbosity, (i.e. debug output). Additional output caused by this option is sent to stderr.
-V, --version: print the version string and then exit.

NOTES¶

For a discussion of referrals see section 4.25 of sbc3r25.pdf at http://www.t10.org (or the corresponding section of a later draft).

EXIT STATUS¶

The exit status of sg_referrals is 0 when it is successful. Otherwise see the sg3_utils(8) man page.

AUTHORS¶

Written by Douglas Gilbert and Hannes Reinecke.

REPORTING BUGS¶

Report bugs to <dgilbert at interlog dot com>.